Recent content by InsufficientPostage

Yeah absolutely. I understand that the cost of two injection molding dies would probably be prohibitive. It’s a bummer to hear that it doesn’t get less stiff. I might just transfer the wire from the old ball-mouse board to the TT Design optical board, and then hack up a black Svideo cable and...

Hey all, is anybody else’s clear ADB mouse button super stiff? It’s so hard to click that it’s almost uncomfortable. It works fine, but I end up using a beige ADB Mouse II most of the time because it’s just so much easier. I suspect that it’s due to the design of the “hinge” being directly...

I had a similar issue. Tone out the connections between UI12 and the rest of the components. I suspect that you have a broken/corroded trace somewhere. I was having internal and external SCSI issues with my SE/30 where the SCSIProbe was reporting the bus was not terminated, and it turned out...

I had this issue with an old Dayna ethernet card on my SE/30, and the only way I solved it was to pick up a CentreCOM 210TS AUI to RJ45 transceiver. Once I plugged that in, and plugged it into my ethernet switch, I had no problem getting an IP address. I think this is an issue with link speed...

Did you ever experiment with this or get an answer? I have an SE/30 with a potentially bad SCSI controller, and grabbed a couple 53C80E's and a 53C80S to try to replace it, but I'm worried that the revisions will somehow not work.