Recent content by maikol

Bumping this to share an update that I have tried with an old Ethernet 10Base-T hub and I was still not able to get it to work. My next step is to attempt in reflashing the EPROM. I have not yet tried to run the card without the EPROM and see if the same error persists. I will try that. In the...

Hello, a semi-related question, I have an Asante MacCon card which I have been trying to troubleshoot. I am considering in reflashing the ERPOM. Can I ask for a photo of your card? Thank you

OK so I've come across a SIMM that looks like this. There are a total of 32 M5116100A chips. I think those are FastPage Memory? Excuse the blurry parts, I used a scanner to take this. "Made in USA" "Quality SIMM" QS28001U I can't find anything on the web. I tried to boot the LC475 but no-go...

Thank you. Good points and suggestions. I have one of those heatsinks lying around and I will put one on before and try the overclock. Hopefully it is not too tall and will fit in the case. Thanks for the tip, I will have it in mind that still a hardware change is needed even if the CPU is rated...

Thank you all very much for the responses and sharing your experiences and perspectives. @ClassicHasClass Your perspective makes sense and is a pragmatic approach. Beyond the collector aspects, one would have to "be there" to experience the speed up, particularly if this was part of the daily...

Hello everyone, I recently got into retro Mac machines after coming from the retro PC side of things. As a beginner, I picked up a basic LC 475 and have done two upgrades so far. I recapped the power supply (it wasn’t even powering on) and upgraded the VRAM. My next step is to recap the...

Hi Fizzbinn, no worries, I’m learning as I go. I think I did this but I just checked again on a new install of System 7.6. Those are good suggestions. TCP/IP set to Ethernet with a static IP AppleTalk gives me “An error occurred attempting to use Ethernet. Make sure your network connections are...

Thank you. In your case, you made the resistor modifications to enable a mode change to 10Base half-duplex?

Hello everyone, first time poster here. I am looking for help in getting an Asante MacCON+ LC NIC to work with my LC475. I have connected through an RJ45 cable and tried a 10/100 Switch assuming that the link negotiation would be an issue. I don't know if it is. Only the green LED comes on. I...