Recent content by P-car

I raised the Qp above 22 - as OdanO suggested - and it sopped locking up mid-roll. Unfortunately, quality is not very good now.

I've noticed that the scanner sometimes stops mid roll , and just freezes up. has anyone else noticed this behavior ? is there a solve? thanks

@OdanO Ive updated my C unit to 7.6.1. My QP is set to 15, but I dont think im getting good Mbps. (the Mbps shown in image are equal to 16, and that's not ideal, correct?)

just updated to 7.6.1 on a C scanner and getting QP=16 and 17 and ISO=50. WOW!! Thank you @OdanO

fantastic!! Ok, so to get 25-27 Mbps, I just set it to the lowest possible number - 15 for example - and let the also do the rest, correct?

what should the default values be in the capture screen for the WB? (cause I screwed them up big time.)

Hello everyone, would some kindly suggest a "white balance" setting and "RGB" values I can input for some old Kodachrome that is slightly blue. I just need a starting point and I can tweak from there. thanks all

ok, so, the "lower" the number of the QP, the "higher" the "bit rate", that the device will attempt accomplish, is this correct?

We currently DO NOT have control over ISO, correct? (the algo manages the iso.)

yes, thank you. that issue resolved after boot up.

OdanO. thank you so much. I'm going also print the parts for the lens MOD. can you suggest a good online 3d print store. I've not done 3d prints in a while.

Darn. My unit did not come with the adapters. what are they called? maybe I can find them on AMAZON. If I cant find on AMAZON, where can I buy in USA? thanks

My Kodak Reels arrived today with the red adapter attached to the left arm and the grey one attached to the right arm. However, my super 8 reels "center hole" are still too large. Do I need another adapter? please see image.

so, I just got my Kodak Reels and was able to get OdanO's firmware up and running. However, when I try to use the "framing" buttons, nothing happens. I try to zoom in and it does not respond, it also does not respond to left or right. so, I shut it off and turned it back on, and when I did, the...

I think the unit NEEDS the 12mm lens I order to be considered a "viable" scanning option.