3D Printing & MacEffects Appreciation

[caver01]

you’ll have to trim out the one you want to use, but there will be options!

 

[JDW]

Looks like a PLA print will now work at JLC3DP, and at a low price too!

Many thanks for your time and effort spent on the modification, @caver01 !

 

[caver01]

Love that price! Shipping will probably be several times higher than that, but I can understand, given all of the options why a service like JLC3DP can make a lot of sense vs. getting in to a DIY setup (and honestly, another big hobby).

If you decide to get these, I am confident one of them will work for you. Counting from the lowest step, the one I am using is the fourth one at 1mm thick. You have options in each direction to adjust your preferred feel.